Skip to content

Yealink phones

Line Set up

  • Press OK button on your phone to display IP address.
  • Enter the IP address in your browser and log in to the phone GUI. The default username and password is "admin".

Yealink web interface login screen

  • Click Account tab.
  • Set the Line Active field toEnabled .
  • Enter your SIP device number in to the Label field (seeSIP devicesto find your number).
  • Enter your SIP device name to theDisplay name field (seeSIP devicesto find your number).
  • Enter your SIP device number in to theRegister name field (seeSIP devicesto find your number).
  • Enter your SIP device number in to theUser name field (seeSIP devicesto find your number).
  • Enter you SIP device passsword in to thePassword field (seeSIP devicesto find your password).
  • Enter the hostname of your Daktela instance into theServer host field – usually the same as the address you use to log in to Daktela, e.g. "yourcompany .daktela.com".

Yealink account settings with the Daktela SIP account - Click Confirm to complete.

Set up the Assisted Transfer

Connect via your phone's IP address in your web browser. Go to Settings β†’ Softkey Layout.

  1. Switch theCustom Softkey to Enabled.
  2. Select from the menu Call States Transfer to .
  3. Move Send into to the top of the right column.
  4. Move Transfer to the left column.
  5. Click Confirm to complete.

Yealink transfer settings

TLS Setup

If you want to have secure connection (especially when you want to configure an IP phone in another country than Czech republic), it is necessary to choose TLS protocol. Set up your phone by following the previous step with 2 changes:

  • Select TLS under Trasport.
  • Change Port to 5061 under Server Host.

Yealink account settings with port 5061 and TLS transport Next, disable accepting trusted certificates only:

  • Go to Security.
  • Click Trusted Certificates and select Disabled in Only Accept Trusted Certificates

Yealink trusted certificates settings

Random Incoming Calls from Nonsensical Numbers

A common cause of nonsensical calls is a PC infected with malicious software located in the same segment of the local network as the phones or an attack from an external network. We therefore strongly recommend separating the telephone network from the PC network either directly in hardware or at least using a VLAN.

Warning

Important Note: The following procedures may resolve the consequence of the problem (that is, the ringing of the phones themselves), but not its cause, which is a local area network vulnerability.

Go to Features β†’ General Information.

Yealink Features General Information page Change Accept SIP Trust Server Only to Enabled and Allow to IP Call to Disabled.

Yealink settings with Accept SIP Trust Server Only enabled and Allow IP Call disabled

Autoanswer on Dect

The Yealink W60B is the only DECT phone you can use with auto-answer.

  1. Upgrade the base station firmware to version 77.85.0.64 (file W600-77.85.0.64.rom).
  2. In the device's web settings, add this configuration:
#!version:1.0.0.1
account.1.auto_external_intercom = 1
account.1.external_intercom.mute = 1
account.1.external_intercom.barge.enable = 1

Reset to Factory Settings

To reset your phone to factory settings hold 10 second button OK.