Skip to main content
Skip table of contents

Minimum Requirements


Infrastructure

Infrastructure

Connectivity and Bandwidth Requirements

  • One-way latency (mouth to ear) no more than 150 ms

  • 100 kbits UP/DOWN per concurrent voice call, plus web traffic bandwidth for the Daktela web interface (average is 100kbits DOWN for each active working agent)

  • Loss no more than 1 percent IP exchanges, VoIP networks

  • Average one-way jitter targeted at less than 30 ms

  • Optional: Voice traffic should be marked to DSCP EF per the QoS Baseline and RFC 3246

  • When using a firewall, the customer must configure and change it for the VoIP and data stream to allow communication between the on premise instance, its phones and the Daktela platform

  • Disabled SIP-ALG on LAN devices and firewall, as default. May be enabled in some specific cases.

  • Due to their complexity, Daktela doesn’t provide support for customer LAN infrastructure and firewalls!

  • Professional LAN network infrastructure based on min. full duplex 100 Mbit/s switches and of type CAT5e or better.

  • The network must not run at full capacity even during peak hours. Adequate capacity must be available for the anticipated voice traffic. It is ideal to separate and prioritise the telephony data, e.g. via VLAN.

  • Separate switches for IP phones and PCs are recommended for high volume data exchange over the local network.

  • IP phones must be assigned a valid IP configuration including internet gateway designated for voice traffic by means of a DHCP server.

For On-Premise Daktela Installations

  • Open Ports for Backup, Monitoring and Remote Management

  • Incoming ports TCP usually 22 (SSH) from: backup.daktela.com - 82.113.42.139; gw.daktela.com - 95.80.200.192; zabbix.daktela.com - 82.113.42.131

  • Outgoing: For upgrade and monitoring purposes of on-premise installations, full access to the Internet is preferred. If it is not possible, please contact Daktela support to set up the necessary firewall exceptions.

For Daktela Implementations in the Daktela Cloud

Allowed Ports for WebRTC Phones

  • For WebRTC phones

    • outgoing 8089/tcp to ip list

    • incoming and outgoing 10000-20000/udp from/to ip list

  • For PBX

    • incoming 5060/udp from ip list

    • incoming and outgoing 10000-20000/udp from/to ip list

  • IP list
    194.176.107.3/32, 194.176.107.4/32, 194.176.107.5/32, 194.176.107.6/32, 194.176.107.7/32, 194.176.107.8/32, 194.176.107.9/32, 194.176.107.10/32, 194.176.107.12/32, 194.176.107.13/32
    45.133.137.215/32, 45.133.137.217/32, 45.133.137.219/32, 45.133.137.221/32, 45.133.137.224/32, 45.133.137.225/32

Allowed Ports for SIP Phones

  • Open outgoing port ( to pbx ): 5061/TCP

  • Open incoming/outgoing port ( from/to pbx ): 5060/UDP, 10000-20000/UDP

Outgoing

Full access to the IP address of the cloud pbx is preferred (can optionally be further limited to these outgoing ports: TCP/80, TCP/443, ICMP, TCP/20, TCP/21, TCP/UDP/123, TCP/44000-44100)


Browsers

Browsers

Min. browser requirements

Daktela supports the latest versions of Chrome, Firefox, Opera , Safari, Edge

Min. requirements for Daktela Wallboards

Daktela supports the latest versions of Chrome, Firefox, Opera , Safari, Edge. Wallboards can also run on Smart TVs and LCDs with the latest versions of supported browsers.


Hardware and Phones

Hardware and Phones

Software IP Phones

Support

 While Daktela V6 should work with all of the SW phones above, Daktela provides support only for the Daktela Software Phone.

Hardware IP Phones

  • Suggested HW phones: Yealink IP phones, Cisco SPA, Siemens Gigaset

  • Phone transport set as UDP, allowed codecs G.711 A-law

Min. computer requirements

  • PC with CPU min. 2.0 GHz (4+ cores ), min. 8 GB RAM (16 GB RAM preferred), Audio In/Out

  • MacBook with min. 8 GB RAM (16 GB RAM preferred)


Emails and Tickets

Emails and Tickets

Requirements to Send and Receive Email Using the Daktela Helpdesk

  • Daktela must be the only mail client using the mailbox.

  • The customer must be aware of the allowed quantity of sent emails to prevent blocking etc.

  • The customer must provide:

    • access to the incoming and outgoing mail server.

    • any additional required parameters.

    • the maximum title characters are 128.




JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.