Skip to content

Yealink phones

Line Set up

  • Press OK button on your phone to display IP address.
  • Enter the IP address in your browser and log in to the phone GUI. The default username and password is "admin".

yealink_en0.jpg

  • Click Account tab. 
  • Set the Line Active  field toEnabled .
  • Enter your SIP device number in to the Label  field (seeSIP devicesto find your number).
  • Enter your SIP device name to theDisplay name field (seeSIP devicesto find your number).
  • Enter your SIP device number  in to theRegister name field (seeSIP devicesto find your number).
  • Enter your SIP device number in to theUser name field (seeSIP devicesto find your number).
  • Enter you SIP device passsword in to thePassword field (seeSIP devicesto find your password). 7. Enter the hostname of your Daktela instance into theServer host field – usually the same as the address you use to log in to Daktela, e.g. "yourcompany .daktela.com".

Acount numbers.png - Click Confirm to complete.

Set up the Assisted Transfer

Connect via your phone's IP address in your web browser. Go to Settings →  Softkey Layout.

  1. Switch theCustom Softkey to Enabled.
  2. Select from the menu Call States Transfer to .
  3. Move Send into to the top of the right column.
  4. Move Transfer to the left column.
  5. Click Confirm to complete.

Transfer numers.png

TLS Setup

If you want to have secure connection (especially when you want to configure an IP phone in another country than Czech republic), it is necessary to choose TLS protocol. Set up your phone by following the previous step with 2 changes:

  • Select TLS under Trasport.
  • Change Port  to 5061 under Server Host.

yealink_en2.jpg Next, disable accepting trusted certificates only:

  • Go to Security.
  • Click Trusted Certificates  and select Disabled  in Only Accept Trusted Certificates

yealink_en3.jpg

Random Incoming Calls from Nonsensical Numbers

A common cause of nonsensical calls is a PC infected with malicious software located in the same segment of the local network as the phones or an attack from an external network. We therefore strongly recommend separating the telephone network from the PC network either directly in hardware or at least using a VLAN.

Warning

Important Note: The following procedures may resolve the consequence of the problem (that is, the ringing of the phones themselves), but not its cause, which is a local area network vulnerability.

Go to Features → General Information.

Screenshot 2022-06-23 134603.png Change Accept SIP Trust Server Only to Enabled and Allow to IP Call  to Disabled.

Screenshot 2022-06-27 092551.png

Autoanswer on Dect

Yealink W60B is only dect which you can use for autoanswer. You need to upload on your base station firmware from here -LINK. You need to set up the configuration on the device web settings:

!version:1.0.0.1

account.1.auto_external_intercom = 1 account.1.external_intercom.mute = 1 account.1.external_intercom.barge.enable = 1

Reset to Factory Settings

To reset your phone to factory settings hold 10 second button OK.